Pan & Tilt Module Kit

Price: $29.95

Stand alone pan/tilt FPV module that uses a custom mechanism allowing for full 180 degree (+/- 90 degree) panning without the need for any modifications to a servo or without the need for a servo stretcher. A full 360 degree pan (+/- 180 degrees) is possible with the addition of an NG Hobbies SSV3.5 servo stretcher

The modules are supplied with quality HXT900 servos.

Note: careful routing of camera wiring is required to prevent binding during 180 degree or 360 degree operation.

The module can be attached to the plane of your choice with four screws. Dimensions listed below in the pictures.

We currently offer camera mounting plates for most popular FPV cameras including: Cased: KX131, KX171, KX191, SN777, SN555, IF Cam, IF OSD Cam, DPC OSD Cam Uncased: DX201 (comes with required additional mounting screws)

Note: Currently the back plates are designed for the pan/tilt system being installed on top of the aircraft. If you plan on mounting the assembly inverted under the aircraft, some modifications to the back plate may be required.

This kit includes:

Laser cut components and required hardware for pan/tilt module.
Two 9g Servos

Note: For the "no servo" option, it is up to the customer to modify the assembly if required. The system was designed for HXT900 servos. Any other servo must be aligned properly for proper gear engagement.

You'll need to supply:

Double sided servo tape to retain camera and tilt servo.
Pull-ties to hold TX against tape and for holding your wiring down.
Medium CA
5 minute epoxy

Customer Reviews:

There are yet no reviews for this product.
Please log in to write a review.