Easy Star FPV Pod Kit

Price: $42.95

Easy Star FPV pod uses a custom mechanism allowing for full 180 degree (+/- 90 degree) panning without the need for any modifications to a servo or without the need for a servo stretcher. A full 360 degree pan (+/- 180 degrees) is possible with the addition of an NG Hobbies SSV3.5 servo stretcher (option below). The pods are supplied with quality HXT900 servos.

A compartment at the rear of the pod is available for your battery. Although designed for a 600 to 900mAh 3 cell batteries, many other batteries will fit in this compartment.

The pod is attached to the Easy Star by a combination of the tabs at the front of the pod and strong rare-earth magnets (included) at the back of the pod.

Comes with a mounting plate that will fit many popular FPV cameras including:KX131, KX171, KX191, IF Cam, SN777, SN555 and others. Additional back plates may be purchased to fit IF OSD Cam, DPC OSD Cam, DX201

Note: careful routing of camera wiring is required to prevent binding during 180 degree or 360 degree operation.

This kit will include:

Laser cut components for the main pod
Laser cut components and hardware for the 180 degree pan module
Two 9g Servos
Four rare-earth magnets
Velcro strap to hold down battery
A single back plate and hinge/control arm for your camera (choose below)

Note: for the "no servo" option, it is up to the customer to modify the assembly if required. The system was designed for HXT900 servos. Any other servo must be aligned properly for proper gear engagement.

You'll need to supply:

Double sided servo tape to apply TX, camera, and tilt servo.
Pull-ties to hold TX against tape and for holding your wiring down.
Medium CA
5 minute epoxy

Manual: EasyPod
See it in action: HERE

Customer Reviews:

There are yet no reviews for this product.
Please log in to write a review.